The most complete LED wiring method, led fluorescent lamp wiring diagram

High-power LED 1W red light imitating lumens LED from Sanan, featuring 30mil gold wire and copper bracket with a brightness of 40 lumens.

GW MB10F 0.8A 1000V rectifier bridge ideal for stabilizing current flow in various electrical circuits.

1206 yellow LED lamp beads offering 1206 yellow light, commonly used in patch LED applications for yellow illumination.

Probe current voltage pin with a size of 420x4450, featuring a head diameter of 5.0mm, designed for detecting overcurrent and voltage conditions.

There are numerous variations of standard fluorescent tubes available online, but their wiring diagrams often lack clarity. For those who aren't familiar with electrical knowledge, this guide should provide some much-needed assistance. I'm confident it will offer convenience!

If you're dealing with a coil-type ballast (inductive) setup, simply removing the starter will allow you to replace it with an LED tube. For even greater efficiency, you can bypass the ballast altogether—this eliminates any energy loss entirely!

In the case of an electronic ballast setup, you'll need to disconnect certain lines as illustrated above and then directly supply power to both ends of the tube. This step is best performed by professionals.

Advantages of LED Fluorescent Lamps:

The LED fluorescent light source utilizes high-brightness LEDs in colors such as cool white, warm white, and daylight white. Compared to traditional fluorescent lights, LED fluorescent lamps offer several advantages:

1. Energy-saving: 80% more energy-efficient than traditional fluorescent lights;

2. Environmentally friendly: No UV or IR radiation, free from harmful substances like mercury, and fully recyclable without causing pollution;

3. Long lifespan: Expected operational life exceeds 50,000 hours;

4. Strobe-free: Operates with constant current, reducing LED light degradation, ensuring rapid startup, and eliminating flickering to protect eyesight;

5. Easy installation: Simply remove the original fluorescent tube and replace it with an LED tube. Remove the ballast and starter, allowing direct connection of 220V AC mains to the two ends of the LED fluorescent tube.

Applications:

Suitable for most indoor lighting needs, including homes, hotels, shopping malls, offices, schools, parking lots, warehouses, factories, supermarkets, entrances, corridors, advertising displays, and more.

1. Wiring methods for traditional fluorescent tubes include electronic ballasts and magnetic ballasts. The wiring diagrams are as follows:

2. Wiring for LED fluorescent tubes: Remove the ballast and/or starter, connect the live and neutral wires to the two ends of the bracket, as shown below:

Installation Notes:

1. Remove the starter and rectifier, and connect the live and neutral wires of the mains to the left and right ends of the bracket.

2. The LED tube has an integrated power supply. The two pins of the G13 interface are short-circuited, and the interfaces at both ends are identical.