Integrated series LED tube installation method
First, how to fix the integrated LED tube (pictured)
The integrated LED tube fittings are equipped with two stainless steel circlips for mounting the LED tube. First, the two stainless steel circlips are fixed according to the length of the LED tube and the position to be installed (two circlips) Distance between the = LED tube length / 3).
Finally, the LED tube is loaded into the fixed card spring.
Second, how to connect the integrated LED tube (pictured)
PS: Two white wires can be connected to the live or neutral wire to illuminate. It is not necessary to distinguish the zero fire wire; the yellow wire is the ground wire and should never be connected to the live wire or the neutral wire.
Third, the integrated installation of LED tube (Figure)
PS: To use this series installation method, you need to consider the number of LED tubes directly connected behind. Assume that in China, the power of each LED tube is 7W. If the cable inside the LED tube is used for the 18# line, you can connect 157 LED tubes (wire diameter * rated voltage * Rated current/power = number of LED tubes), reserve a part of space, or connect 100 LED tubes.
Bracket lamp series installation method
The bracket LED tubes used in homes and offices are equipped with ballasts, which are divided into electronic ballasts and inductive ballasts.
One: LED fluorescent lamp is installed in the inductor rectifier bracket installation mode, as shown below
Note: It is strictly forbidden to install this LED fluorescent lamp before the starter and rectifier are removed. Otherwise, the LED lamp will burn out.
Two: LED fluorescent lamp installed in the electronic rectifier bracket installation instructions
a. Remove the electronic rectifier according to Figure 1. Connect the live (L) and neutral (N) wires to the ends of the LED tube as shown in Figure 1.
Note: 1. The inside of the wire frame is the part of the original fluorescent electronic rectifier that needs to be removed, and the external solid line is the wiring mode of the LED tube.
b. All the wire connections are made of electrical tape as shown in Figure 2. The terminal block is insulated and no conductive parts are allowed to be exposed.
Third, the bracket lamp installation effect display
Emergency LED drivers are designed specifically for light fixtures . These emergency backup drivers regulate the power supplied to the LED fixture the same way normal drivers do , but they operate off of a battery instead of line voltage . Because they operate off a battery the light output isn't as bright as the fixture normally would produce , but it will be just enough in an emergency situations . Most of our emergency LED drivers have a maximum emergency operation time of 120 minutes .
Emergency Inverter Kit,Battery Backup LED Lighting,LED Emergency Light Module
Jiangmen City Pengjiang District Qihui Lighting Electrical Appliances Co., Ltd , https://www.qihuilights.com